Page 1 of 1
No redirection after setup wizard
Posted: 16 Nov 2021, 15:15
by dagonix
When you run the wizard after install and if you change the LAN IP address, the redirection will fail because you'll be redirected to the former LAN IP address.
Re: No redirection after setup wizard
Posted: 16 Nov 2021, 15:42
by gregober
Thank you for reporting this problem. We will try to fix it.
[b]Please try to post in the DynFi Firewall section if questions are related to DynFi Firewall. [/b]
Re: No redirection after setup wizard
Posted: 16 Nov 2021, 18:09
by dagonix
Sorry, I posted to → Using DynFi Firewalls / General questions. I don't see a section called DynFi Firewall
And by the way, the no redirection problem is not only "Wizard related". Even after the setup, if you change the LAN address IP, the redirection does not occur. The same goes if you change the TCP port.
Thank you.